Apricorn Aegis Bio Bedienungsanleitung PDF herunterladen (Seite 8)

Getting Started - Out of the Box

1. Attach the integrated USB cable of

the Aegis Bio to an available USB

port on your computer. The Aegis

Bio LEDs will show Solid BLUE and

Flashing GREEN indicating that the

drive is ready to enroll your ngerprint.

2. Swipe your Finger. The BLUE LED

will turn off while the GREEN LED

starts to icker briey as the Aegis Bio

processes your ngerprint.

Wait until the BLUE LED turns back

to Solid BLUE and the GREEN LED

returns to its ashing state.

3. Continue to repeat Step 2 until both

the BLUE and GREEN LED are

in a solid state, indicating that your

ngerprint is fully enrolled.

NOTE: The number of attempts will vary depending on the quality of

the ngerprint read. For most people six swipes will be sufcient.

If there is a problem with a ngerprint read, the BLUE LED will turn off and

the RED LED with start to ash.

4. To enroll more ngerprints, press the ENROLL button within 15

seconds from your last successful ngerprint enrollment and repeat

the process in steps 2 and 3.

NOTE: A maximum of 5 ngerprints can be stored. There is a 15 second

timeout between entering ngerprints. If the ENROLL button is not pressed

again after the last ngerprint, the unit will assume no more ngerprints will

be entered and return to a standby state.

Once 5 ngerprints have been stored, all three LEDs will turn on. After 2

seconds the GREEN and BLUE LED will turn off with just the Solid RED

LED showing. At this point no more ngerprints can be enrolled.

NOTE: Once enrolled, ngerprints cannot be un-enrolled

individually. To remove enrolled ngerprints, a complete re-set

of the drive is required.

TIP: We highly recommend that you enroll at least three

different ngers to ensure access to the drive in the case

that your primary nger cannot be used.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Apricorn Aegis Bio Bedienungsanleitung Seite 8